Behavior After Power Restoration; Maintenance And Cleaning - HomeMatic HM-Sys-sRP-Pl Operating Manual

Slow flashing
Fast flashing
One long, x-short (depends on the type of
error)
9

Behavior after power restoration

After switching the operating voltage on (mains voltage returned),
the repeater checks the respective components. If an error is
detected during this test, it is indicated by a flashing LED. This is re-
peated continually and the device starts to work with the respective
functionality. If the test runs without any errors, the repeater sends a
radio telegram with the respective status information. The repeater
waits a random delay time before sending so that all actuators are
not sending at the same time when the power returns (after a power
outage or shut-down). During this time, the device LED flashes (like
in teach mode). If the delay time is short, the flashing may not even
be noticeable.
10

Maintenance and cleaning

This product is maintenance-free. Repairs are only to be done by
trained professionals.
18
Teach mode
Reset
Error