Resetting To Factory Status; Device Led Feedback Messages; Flash Codes - HomeMatic HM-Sys-sRP-Pl Operating Manual

7

Resetting to factory status

In order to reset the repeater to factory status, switch the device to
teach mode with the channel button (B) (hold button pressed for at
least 4 seconds). If the device is in teach mode, hold the channel
button (B) pressed down for at least 4 seconds. The repeater reset
is indicated by the device LED flashing quickly.
8

Device LED feedback messages

8.1

Flash codes

Different actuator states are indicated by the channel LED/channel
LEDs flashing:
> 4 Sek.
17