Bosch Dishwasher Instructions For Use Manual page 16

en
Note
Optimum rinsing and drying results can be
obtained by using standard detergents in
conjunction with separate application of
salt and rinse aid.
Observance of the operating instructions
or information on the packaging of the
combined detergents determines their
effectiveness.
Note
Even if the rinse aid and/or salt refill
indicator is lit, the rinse programme runs
correctly when 3in1 products are used.
If the rinse aid refill indicator
refill indicator is defective and you
7
would like to switch it off, proceed as
follows:
Switching the rinse aid refill
indicator off and on
You can switch the rinse aid refill indicator
on or off. This function can be
8
changed as follows.
Hold down the programme button
and press the main switch
digital display lights up, then release the
buttons.
is indicated on the digital display
4
(rinse aid refill indicator on).
By pressing the programme button
, you can switch off
3
on the rinse aid indicator.
Switch off the main switch
the setting is saved.
16
Downloaded from DishWasher-Manual.com Manuals
Switching the salt refill
indicator / water softening
system off and on
or salt
8
Approx. 4 litres of water are required to
regenerate the water softening system.
As a result, the water consumption per
rinse cycle increases by 0 to maximum
4 litres depending on the water hardness
setting.
3
until the
1
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
or switch
system has been set to the correct water
hardness.
;
1
Hold down the programme button B
and switch on the main switch
then release the buttons.
The illuminated button B and the
factory-set value
display flash.
To change the setting: press the
programme button B .
Each time the button is pressed, the set
value increases by one; when the value
is reached, the display jumps back
to (the salt refill indicator / water
softening system has been switched
off).
Switch off the main switch
The set value is stored within the
device.
Note
,
1
on the digital
.
1