Table of Contents
Advertisement
Rotate the door
▀
As standard Effecta Lambda is delivered with door hinges on the right side. If you need to re-
place the door hanging follow instructions below.
Upper hatch
1. Start by loosening the two M12 bolts that hold the hatch in the against the frame. Remem-
ber to have a shelter over the hatch to avoid scratches in the paint with continued work.
2. Also loosen the two M12 bolts that hold the locking device in place. The new lock is sup-
plied with boiler, the existing is not to be used.
3. Remove the two M12 bolts that hold the thermal insulation in place. Manage the insulation
carefully as it easily gets splinters.
4. Remove the two door gaskets.
5. Then remove the two small bolts that hold the angle (6) which is the upper insulation strip
in place.
6. Reassemble the thermal insulation into the two holes located above the original holes. Re-
place gaskets and then finally the angle plate. Remember not to twist gasket when refitting.
Lower hatch
The lower door is rotated by following step (1-2).
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - +46 (0)300 22320 - info@effecta.se
21
Advertisement
Table of Contents
