Protective equipment such as dust mask, sure that the safety of the power tool is maintained. non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. 1 609 92A 0ML | (9.4.14) Bosch Power Tools...
Page 7
Products sold in AUS and NZ only: Use a residual current de- power tool is restarted in the workpiece. vice (RCD) with a rated residual current of 30 mA or less. 1 609 92A 0ML | (9.4.14) Bosch Power Tools...
Protection class Angle Grinder GWS ... 24-230 24-230 26-180 Article number 3 601 ... H84 1.. H84 2.. H55 1.. Rated power input 2400 2400 2600 Output power 1600 1600 1700 Bosch Power Tools 1 609 92A 0ML | (9.4.14)
Page 9
Only for power tools without reduced starting current: Starting cycles generate brief voltage drops. Interference with other equipment/machines may occur in case of unfavourable mains system conditions. Malfunctions are not to be expected for system impedances below 0.25 ohm. 1 609 92A 0ML | (9.4.14) Bosch Power Tools...
Page 10
Protection Guard for Grinding (Clamping Screw) Quick-clamping Nut (GWS 20-230 H/GWS 22-180 H/GWS 22-230 H/JH/ With the quick-clamping nut 9, grinding tools can be mounted GWS 24-180 H/GWS 24-230 H/JH/GWS 26-180 H/ without additional tools. GWS 26-230 B/H) ...
Page 11
M 14 8500 Before mounting the rubber sanding plate 14, attach the 2 spacer discs 13 to the grinder spindle 4 (GWS 20-230 H/ GWS 22-180 H/GWS 22-230 H/JH/GWS 24-180 H/ GWS 24-230 H/JH/GWS 26-180 H/GWS 26-230 B/H). Screw on the round nut 16 and tighten with the two-pin span- ner.
34 to the re- quested position until it latches. Switching On and Off Rotating the Machine Head (GWS 20-230 H/ To start the power tool, press the On/Off switch 2 forward and then down.
Before beginning work, consult the responsible structural Do not reduce the speed of running down cutting discs by ap- engineer, architect or the construction supervisor. plying sideward pressure. 1 609 92A 0ML | (9.4.14) Bosch Power Tools...
Please store and handle the accessory(-ies) carefully. If the replacement of the supply cord is necessary, this has to Republic of South Africa be done by Bosch or an authorized Bosch service agent in or- Customer service der to avoid a safety hazard.