Maintenance - Klutch 24V Cordless 1/2in. Impact Wrench Instruction Manual

OPERATING PROCEDURES
ROTATION DIRECTION
Your tool is equipped with a 3-position Forward / Reverse / Neutral Lock Switch
through the housing above the trigger. When knob is pushed toward the right,
rotation is forward (clockwise). When pushed in from the right to the left side,
rotation is reversed (counter-clockwise), and when in center position, it is locked
in neutral and the trigger is blocked. Do not push the rotation direction knob until
the drive stops turning.
BATTERY PACK
1. Battery must be charged before using tool for the first time. Batteries will
reach full performance after about fi ve charge/discharge cycles.
2. Always have 3-position Forward / Reverse / Neutral Lock Switch in the center
position when removing or inserting battery to avoid unintentional starting.
3. Remove the battery from the tool. Press the Battery Release Button and
remove battery.
4. Place battery on the charger.
5. To charge, plug the charger's AC input plug into a 110/120V household current.
6. When battery is charging, red light is on. When battery is finished charging, a green
light comes on.
7. IMPORTANT: Ensure that charging takes place in a safe, secure location away
from liquids.
8. Normal charging time is approximately 1 hour.
9. To insert the battery into the tool, simply slide the pack in until Battery Release Button
lock spring clicks.
10. When charging more than one pack in succession, allow 15 minutes between charges.
11.
The battery discharges slowly over time, even when not used, and may require
recharging before you use the tool.
12.
After many charge/discharge cycles, your batteries will lose their ability to hold a
charge. They should then be replaced. Dispose of batteries at an appropriate waste
disposal facility. They contain cadmium, so do not throw batteries away in common
trash receptacles.

MAINTENANCE

•
Keep the tool clean using a soft damp (not wet) cloth. Do not use solvents
on the plastic parts.
•
Lubrication is not necessary. After long use, have an authorized service
center maintain and lubricate the tool.
5