Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Klutch 375356
Summary of Contents for Klutch 375356
- Page 1 Pneumatic Multi-function Tool OWNER'S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item # 375356 1209...
-
Page 2: Intended Use
Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., INC. Product! For future reference, please complete the owner's record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. -
Page 3: Personal Safety
• Be alert of your surroundings. Using power tools in confined work areas may put you dangerously close to cutting tools and rotating parts. PERSONAL SAFETY • Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. -
Page 4: Initial Tool Set Up/Assembly
Note:Air source Never connect to an air source that is capable of exceeding 90 PSI. Over pressurizing the tool may cause bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. -
Page 5: Air Supply
Unpacking Note: This air tool may be shipped with a protective plug covering the air inlet. Remove this plug before set up. Air Supply WARNING TO PREVENT EXPLOSION: Note: Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool. -
Page 6: Know Your Product
Know Your Product Knob for air flow control Air Inlet 3 in. Triangular Sanding Pad (45) Trigger Lever (41) Safety Catch (38) Sandpaper (46) Hex Wrench (43) Figure 1 OPERATION: Turn the tool off, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the switch to its off position before assembling or making any adjustments to the tool Work Piece and Work Area Set Up •... - Page 7 General Opreating Instructions • If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use. Add a few drops more after each hour of continual use. • To install an accessory: Figure 3 a.
-
Page 8: User Maintenance Instructions
• Do not remove the Safety Catch. It has been included for your safety. Without it, the tool could activate when it is bumped against something, set down on its Trigger Lever, or picked up while accidently pressing on the Tigger Lever, activating the tool. -
Page 9: Troubleshooting
Trouble shooting... -
Page 12: Warranty
WARRANTY One-year Limited Warranty WARNING Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: •...