Error Messages - Marshall-Tufflex e-Tracker Operating & Maintenance Manual

Error messages

After switch on and during the set up the display will indicate an unacceptable connection.
Check CTs and voltage reference input (if used), correct any error, press ENTER and
proceed with set-up.
1)
ERROR
-- --
(3 messages flashing)
No CTs connected
2)
ERROR
-- --
MTH-DAY HRS-MINS
2011 07.14 10.40
(3 messages flashing)
CTs have different full scale current ratings or only two are connected
3)
ERROR
-- --
MTH-DAY HRS-MINS
2011 07.14 10.40
(3 messages flashing)
If three phase volt probes connected but only one CT connected
4)
ID ERR 1
--
MTH-DAY HRS-MINS
2011 07.14 10.40
(2 messages flashing)
Two CT connected to same phase
5)
ID ERR 2
--
MTH-DAY HRS-MINS
2011 07.14 10.40
(2 messages flashing)
CTs wrong way round or CTs not in l1 connector when used on single phase
8
e-Tracker portable energy monitor operating and maintenance manual
TRANSDUCER
TRANSDUCER
MTH-DAY
2011
TRANSDUCER
MTH-DAY
2011
NOT 3 PHASE
-- --
MTH-DAY
2011
CTS ODD
-- --
MTH-DAY
2011
HRS-MINS
07.14 10.40
HRS-MINS
07.14 10.40
--
HRS-MINS
07.14 10.40
--
HRS-MINS
07.14 10.40
NO CT
-- --
MTH-DAY HRS-MINS
2011 07.14 10.40
CT1-2-3 ODD
--
MTH-DAY HRS-MINS
2011 07.14 10.40
VOLTS CT ODD
--
MTH-DAY HRS-MINS
2011 07.14 10.40
VOLTS CT ODD
--
--