Kodak EASYSHARE CX4230 User Manual page 69

Camera
Problem
Stored pictures are
damaged.
Pictures remaining
number does not
decrease after
taking a picture.
Picture is not clear. The lens is dirty.
Chapter 9
Cause
The card was removed
when the ready light was
blinking.
Picture does not take up
sufficient space to
decrease the picture
remaining number.
Subject too close when
taking picture.
Camera may be in Close-
up (page 19) and the
subject is too far away
for proper focus.
Subject or the camera
moved while the picture
was taken.
The subject is too far
away for the flash to be
effective.
Solution
Make sure the ready light is
not blinking before
removing the card.
The camera is operating
normally. Continue taking
pictures.
Clean the lens (page
Move so there is at least 1.6
ft (0.5 m) between the
camera and the subject; or
turn on Close-up
Turn off Close-up
Hold the camera steady
while taking the picture.
Move so there is no more
than the following distance
between the camera and the
subject: 12.8 ft (3.9 m) in
Wide angle; 7.5 ft (2.3 m) in
Telephoto.
82).
(page 19).
(page 19).
61