Kodak EASYSHARE CX4230 User Manual page 68

Camera
Problem
Picture is too dark. Flash is not on or did not
Camera freezes up
when a card is
inserted or
removed.
Picture is too light. The flash is not needed. Change to Auto flash
60
Chapter 9
Cause
function.
The subject is too far
away for the flash to have
an effect.
The subject is in front of
a bright light (backlit).
Lighting condition is too
dark.
Camera detects an error
when the card was
inserted or removed.
The subject was too
close when the flash was
used.
Lighting condition is too
bright.
Solution
Turn on the flash
Move so there is no more
than the following distance
between the camera and the
subject: 12.8 ft (3.9 m) in
Wide angle; 7.5 ft (2.3 m) in
Telephoto.
Use Fill flash (page
change your position so the
light is not behind the
subject.
Increase exposure
compensation (page
Turn the camera off, then
back on. Make sure the
camera is turned off before
inserting or removing a
card.
(page 16).
Move so there is at least 1.6
ft (0.5 m) between the
camera and the subject.
Decrease exposure
compensation (page
(page 16).
16) or
21).
21).