Cleaning - Sharper Image Steam Wizard SM420 Instructions Manual

CLEANING

Clean after each use or during use if the collection chamber becomes full.
Disconnect the Steam Wizard from the wall socket and hold the
unit over a wastebasket, pointing the nozzle down.
Release the locking tab located under the front of the nozzle.
Pull the chamber away from the unit.when you open the collec-
tion chamber.
Locking Tab
Refer to the parts diagram on the unit (visible once the chamber
is removed). Remove, empty and clean all parts shown on the
parts diagram.
Empty the chamber by shaking it over a wastebasket. Rinse the
chamber and filter under running water to remove excess dirt.
Reassemble the unit to continue using the Steam Wizard. Once
cleaning is complete, the chamber and attachments should be
washed in warm soapy water before final reassembly and storage.
To empty the water tank, unplug the unit from the wall and hold
it over a drain or sink. Remove the water tank cap and turn the
nozzle up to drain the excess water from the tank.
DO NOT over tighten the water tank cap when replacing it.
Tighten the cap only until resistance is felt and it cannot turn
further without force.
NOTE The water tank must be emptied before the unit is stored.