Advertisement
S
AFETY
CAUTION: Before installation, disconnect the battery
negative (-) terminal to prevent damage
to the unit, fire and/or possible injury.
PRACTICE SAFE SOUND™
Continuous exposure to sound pressure levels over 100dB may
cause permanent hearing loss. High powered auto sound systems
may produce sound pressure levels well over 130dB. Use common
sense and practice safe sound.
C
C
ARTON
ONTENTS
•
(1) Set Marine Grade M2 Wakeboard Tower Speakers
•
(1) Set of adjustable swivel clamps
•
(1) Allen head wrench
•
(1) Molex speaker harness
•
(1) Set of rubber inserts for 1 1/2" - 1 3/4" applications
•
(1) Set of rubber inserts for 1 7/8" - 2 3/4" applications
I
C
NSTALLATION
ONSIDERATIONS
Before beginning any installation, follow these simple rules:
1.
Be sure to carefully read and understand the instructions before attempting to
install these speakers.
2.
For safety, disconnect the negative lead from the battery prior to beginning the
installation.
3.
For easier assembly, we suggest you run all wires prior to mounting your speakers
in place.
4.
Use high quality connectors for a reliable installation and to minimize signal or
power loss.
5.
Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines,
brake or hydraulic lines, vacuum lines or electrical wiring when working on any
vehicle. If installation in a boat, take care not to cut or drill through the main hull.
6.
Never run wires in the open area of the boat. Running the wires inside the wake-
board tower and hull area provides the best protection.
7.
Avoid running wires over or through sharp edges. Use rubber or plastic
grommets to protect any wires routed through metal.
M
OUNTING
1.
Determine where the speakers will be mounted. Be sure that the mounting loca-
tion has sufficient clearance in all directions for the speaker to swivel; conduct a
full rotation to ensure there is no obstruction.
2.
Mark the locations on the underside of the clamping surface for the speaker har-
ness to be feed through. Drill the holes with a 3/8" bit.
3.
Feed the speaker wires through the hole and connect to the speaker harness. Be
sure to observe proper polarity when connecting the wires.The speaker harness's
negative wire is indicated with a "black-stripe".
4.
Feed the speaker harness through the center of the base of the clamp. Fit the
clamp to the mounting area and tighten the bolts evenly with the supplied allen
wrench.
NOTE:
Use the proper rubber insert for the corresponding clamping diameter.
Adjusts to fit
1 1/2"
1 3/4"
(3.81cm)
(4.45cm)
Adjusts to fit
1 7/8"
2 3/4"
(4.76cm)
(6.99cm)
Advertisement
