Table of Contents
Advertisement
1) Turn off the power switch at the front side of the display.
2) Wait for about 5 seconds and press MODE, POWER switch with 1 second interval, press MENU.
3) The SVC OSD menu contains additional menus that the User OSD menu as described below.
a) Auto Level: PASS FAIL
b) R/G/B-Gain: Allows you to set the R/G/B-Gain value manually. (Analog Only)
c) R/G/B-Offset: Allows you to set the R/G/B-Offset value manually. (Analog Only)
d) R/G/B-6500K: Allows you to set the R/G/B-6500K value manually.
e) R/G/B-9300K: Allows you to set the R/G/B-9300K value manually.
f) R/G/B-User: Allows you to set the R/G/B-User value manually.
g) R/G/B-sRGB: Allows you to set the R/G/B- sRGB value manually.
h) R/G/B-Nor: Allows you to set the R/G/B- Nor value manually.
i) Burn In: OFF
e) Panel Sel: TPVTPM190AWXGA
Connect to
the PC
Copyright © 2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
SERVICE MODE
Figure 1 Cable Connection for Micom uploading
- 16 -
Connect to
the monitor
LGE Internal Use Only
Advertisement
Table of Contents
