Siemens WM 1065 Operating And Installation Instructions page 31

Fault
Control lights do not
come on.
Programme does not start.
Water does not enter the
machine or detergent is
not wash away.
,,
Rinse and Spin/End
indicator lights flash.
Detergent in chamber I is
not wash away.
Water cannot be seen in
drum.
Washing solution is not
completely drained. The
,,
Ready/Wash and Spin/
,,
End indicator lights flash.
Water is flowing out from
underneath the machine.
Foam coming out of the
detergent dispenser.
Cause
A fuse has triggered.
Power failure.
Plug is loose or not inserted.
Start button does not
pressed.
Water tap not turned on.
Supply hose kinked or
,,
trapped.
Strainer in supply hose
clogged.
A program without Prewash
was selected.
This is not a fault.
The water lies below the visible part of the drum.
Loose debris is blocking
the pump.
Fluff-producing laundry was
washed at a high temperat-
ure. The water drainage
pipe or drain hose is blocked.
The thread of the supply
hose is not tight.
Leak in the drain hose.
To much detergent.
Action
Switch on/replace the fuse.
Call Customer Service if this fault
is repeated.
An interrupted programme will be
resumed when power returns. If
you wish to unload the laundry,
proceed as in Cleaning the drain
,,
pump , Page 24.
Press the Start/Pause button.
Turn on water tap.
Clean the strainer
(refer to Page 26)
Select 90 C Cottons/coloureds
,,
+ prewash .
Clean the pump.
(refer to Page 24)
Clean the water drainage pipe
and/or drain hose.
Tighten the thread.
Replace the drain hose.
Mix1 tablespoon of fabric softener
with 1/2 litre of water and pour
into chamber I of the detergent
dispenser.
Reduce the amount of detergent
next time.
,,
29