Acom 03AT Operating Manual page 9

Fig.2-4 Power supply cable gland of the remote unit (bottom view).
Drag the detached (10-12mm or ½")-piece of the cable sheath towards the cable end in order to loose the shielding
braid. Remove the cloth layer from the shield and carefully spread the braiding wires below it in a radial direction.
Move the plastic insert towards the bared area until the insert face reaches the split braiding. Then bend the
shielding wires back in order to lay them over the outside surface of the plastic insert (fig.2-5). Put them in order and
arrange carefully around the insert periphery.
Fig.2-5 Screening braid shaped before to push into the cable gland.
Holding the plastic insert fixed to the cable, push all four cable cores into the gland housing and direct them towards
the "Power Supply" PCB inside (fig.2-2,c-d). Use a small rotation around the insert axis in order to align its three
guides to the corresponding grooves in the metal housing, then carefully shove the insert into the gland body,
together with the shaped cable. Now, press the insert inwards in a manner that the back-folded braid touches the
metal-housing head closely, and while holding it in this position, screw in the metal cap against stop. Finally, tighten
the cap using a wrench size 20mm (25/32"). Use only enough force while tightening in order that the cable be tight
and could not slip out when pulled occasionally (do not overdo in order not to damage the gland thread).
8