HTC 950 RX Manual page 20

Machine description
Figure 3-3. Control panel
1.
2.
3.
4.
5.
6.
7.
8.
9.
When the machine is not to be used, the knob "Start/Stop" must always be turned to the
Stop position and the knob "Radio On/Off" (5) is always turned to the Off position. The
knob (5) being in the Off position is indicated by the "Radio Enabled" (4) indicator
going out.
12
Power - Standby indicator: Indicates that the machine's functions have been
activated. Shines with a green glow when the start key (9) is turned to the right
(On).
Overload - Overload indicator: Lights up to indicate that the machine is using
too much power. If this is ignored, the power supply to the motor will be
interrupted and an error code generated.
Com Error - Communication error indicator: Lights when there is a
communication error between the grinding machine and the radio control unit.
Radio Enabled - Radio control indicator: Lights when the knob "Radio
On/Off" is turned to the right (On).
Radio On/Off - Turn the knob to the right, when the grinding machine is to be
manoeuvred via radio control.
Speed - Rotation speed: Regulates the rotational speed of the machine's
grinding discs. This is only possible when the grinding discs rotation is started
via the "Start/Stop" knob.
Start/Stop -Start/stop the grinding discs' rotation. Turn the knob to "Start" to
start the rotation, turn the knob to "Stop" to switch off the rotation.
EM-Stop-Emergency stop switch: Press the switch in an emergency to cut the
power to the machine.
On/Off - Start key to start/stop the machine's functions: Turn the key to the
right (On) to activate the machine's functions and prepare for starting. Turn the
knob to the left (Off) to switch off the machine's functions.
HTC 950 RX
1.0