Pioneer AVH-X7700BT/XNUC Service Manual page 69

5
Removing the Monitor Unit (Fig.7)
1
Disconnect the three connectors.
2
Remove the two Gaskets.
Attention at assembly:
Attach the Gaskets as shown in the photo
when mounting the Monitor Unit.
3
Release the two latches and then remove
the Monitor Unit.
Attention at assembly:
Styling cable as like photo.
Removing the Main PCB Unit and the SW PCB Unit (Fig.8)
1
Remove the two screws.
2
Remove the six screws and then remove
the Cover.
3
Remove the five Gears.
(When installing the Gears, please use
caution not to mistake the installation
position)
4 Remove the five solders.
5
Remove the screw and then remove the
Main PCB Unit.
6
Remove the Washer, Arm(1) and the Torsion
Spring.
7
Remove the Washer, Arm(2) and the Torsion
Spring.
8
Remove the screw and then remove the
SW PCB Unit.
Note:
As Main PCB Unit and SW PCB Unit are
connected with FFC, Main PCB Unit and
SW PCB Unit are removed at the same time.
5
6
Grille
3
2
1
1
1
2
2
3
SW PCB Unit
Arm(2)
7
4
Arm(1)
6
8
AVH-X7700BT/XNUC
6
7
Attention at assembly:
Be careful of not pinching FPC from
Monitor Unit when you mount the
Grille.
1
Monitor Unit
Cover
1
2 2
3
3
3
Main PCB Unit
5
4
4
7
8
A
3
2
B
Fig.7
C
2
2
D
3
E
F
Fig.8
69
8