Whirlpool APARTMENT MAINTENANCE SERIES Service Manual page 11

3. Screw the lock nut down to within 1/2 inch of the base of the leg. (Fig. 1-5)
4. Tilt the washer forward off the floor and set back down to adjust the rear self-leveling legs.
5. Check the washer for level, both side-to-side and front-to-back. Adjust the front legs as
necessary. Tighten the locking nuts to the base of the washer with a wrench. If the nuts
are not tightened, the washer may vibrate excessively.
6. Cut the shipping strap at the words "CUT HERE" and slide it off the power supply plug.
(Fig. 1-6)
7. The hook-end of the drain hose can be installed into a stand pipe (Fig. 1-7, A&B) or laundry
tub, (Fig. 1-7, C) and secured with the shipping strap as shown.
A
B
STRAP
Fig. 1-7
3
Fig. 1-5
Fig. 1-6
C
STRAP