Diagnostic Test Program - Whirlpool APARTMENT MAINTENANCE SERIES Service Manual

The Diagnostic Test Program is designed to be an aid for authorized service technicians to objectively
test the washer's water fill valves, drain pump and the clutch/brake solenoid, drive motor, water level
sensor, lid switch, LEDs and rotary switches. There are four tests in the program all accessed from
the control panel by following a specified entry sequence. NOTE: Check the Tech Sheet provided
with the washer for most recent test sequences.
Entry Sequence
The entry sequence to begin the Diagnostic Test Program is as follows:
1. Set the TEMP SELECT switch for the desired test according to the following table:
Table 7
2. Unplug the washer power cord from the household outlet for more than five seconds.
3. Plug the washer back into the electrical power outlet.
4. Set the CYCLE SELECT switch so the flat on the stem faces position 1 - Knob points to
the right. (Fig. 30)
Fig. 30
5. Press and hold the START/PAUSE button while turning the CYCLE SELECT switch one step
clockwise.
6. Release the START/PAUSE button.
NOTE: To terminate any diagnostic test and return to normal operation, unplug the washer power
cord from the power outlet for more than five seconds and then plug the power cord back into the
outlet.

DIAGNOSTIC TEST PROGRAM

TEST
Actuator and Switch Test
(PREFERRED SERVICE TEST)
Automatic Operations Test
Interface Test*
*Interface Test
available on 4-temperature models
Permanent
Press
Delicate
Soak
61
TEMP SELECT
SETTING
Hot/Cold (HC)
Cold/Cold (CC)
Warm/Warm (WW)
Off
Super
Wash
Cottons:
Heavy
Cottons:
Normal
Spin Only
Flat of
Shaft