Accessing Component Inside The Washer Cabinet - Whirlpool APARTMENT MAINTENANCE SERIES Service Manual

ACCESSING COMPONENTS INSIDE THE WASHER CABINET
Components inside the washer cabinet can be accessed by completely removing the outer cabinet as
one unit. Refer to Figure 3-8 for the following instructions.
1. Remove the console mounting screws and tilt the console into the service position.
2. Unplug the lid switch harness connector from the receptacle in the washer top.
3. Remove the cabinet mounting clips by placing the flat blade of a screwdriver in the clip as
shown in Figure 3-8, Inset 1 .
CLIP
4. Remove the cabinet by tilting it forward and pulling it away from the washer. (Fig. 3-9)
Fig. 3-9
NOTE: If necessary, the washer can be operated
in all cycles with the cabinet removed.
Install a jumper wire in the lid switch
harness connector as shown. (Fig. 3-10)
IMPORTANT: Use extreme caution when
operating the washer with
the cabinet removed.
Fig. 3-8
CLIP
HARNESS
CONNECTOR
19
INSET 1
CABINET
VIOLET
GRAY
Fig. 3-10
JUMPER
WIRE