JVC MX-K1 Service Manual page 16

MX-K1
Removing the cassette deck heads
Prior to performing the following procedures,
remove the top cover.
Also remove the CD changer unit.
Also remove the front panel assembly.
1. Remove the five screws "O" that retain the cassette
deck mechanism.
2. Remove the cassette deck mechanism and place it
so that the front side faces up.
3. Remove the solder from the bottom side of the
head terminal and disconnect the wire.
4. Remove the screw "U" that retains the head.
5. Loosen the screw "V" that retains the head.
6. Hold the head and slide it in the direction of the
arrow to remove it.
Removing the 3-pin regulator
Prior to performing the following procedures,
remove the top cover.
Also remove the rear panel. (See Fig.33)
1. Remove the screw "W" that retains the bracket
holding the 3-pin terminal regulator.
2. Remove the solder fixing the 3-pin regulator.
1-16
(See Fig.21 and 30)
(See Fig.31 and 32)
Cassette deck mechanism
(Front side)
PB Head
V U
Fig.30
Power amp
and supply PCB
W
Fig.31
Power amp and supply PCB
Fig.32
REC/PB Head
V U
Heat sink
Heat sink
Solder on the
3-pin regulator