Installation & Operation
Before installing the device:
1. Please read the User Manual before proceeding the installation.
2. Use high performance cables.
3. Please turn off power of all the sources and display devices.
Installing ET-H4T2100:
1. Connect HDMI source and Transmitter HDMI Input with a HDMI cable.
2. Connect HDMI display devices and Transmitter HDMI Output 1 with a HDMI cable if
necessary.
3. Connect two ends of LAN cable (preferably CAT6) to Transmitter RJ-45 output and Receiver
RJ-45 Input.
4. Connect RS-232C cable and IR Cables if necessary.
Installing ET-H4R2100:
1. Connect HDMI display devices and Receiver HDMI Output 2 with a HDMI cable.
2. Connect HDMI display devices and Receiver HDMI Output 3 with a HDMI cable if necessary.
3. Connect RS-232C cable and IR Cables if necessary.
!! Caution !!
Please be aware when you connect IR cables.
Wrong wiring of cables may cause fatal damage to the receptacle of IR cables.
IR IN = Cable with the ROUND type module
IR OUT = Cable with the STICK type module