PetPal S.P.O.T. Owner's Manual page 7

Be sure to check that the antenna is securely fastened
to the transmitter before each use. Hand tighten only.
Be careful when screwing the antenna into the trans-
mitter. Over-tightening the antenna can cause dam-
age to the antenna or the antenna mount.
The red dot indicates the magnet location
and is used to turn the collar receiver ON/
OFF and for ID programming.
Transmitter LED Indicator Light
When any of the buttons on the transmitter is pushed,
the red LED light will turn on to indicate that the trans-
mitter is being operated. If the red LED light blinks
rapidly after pressing any of the transmitter buttons,
the 9-volt battery will need to be replaced soon.
Night Sight™ & Remote Training Buttons
Pressing the "LITE" button will cycle through a con-
stant 50% brightness, constant 100% brightness,
blink/strobe at 100% brightness, and back to off on the
Night Sight™ LED lights. Holding the "BLNK" button
will make the Night Sight™ LED lights blink until re-
leased. Pressing the red Vibration Assist™ button on
the left side will make the collar vibrate until released.
PARTS & FUNCTIONS
Transmitter Antenna
Magnet Indicator (Red Dot)
7