APW Wyott SHFWEZ-1 Installation And Operating Instructions Manual page 4

APW EZFILL HOT FOOD WELLS
Part Numbers Beginning with WHFW
Drain
E
12.02
(305) Water
1
Inlet
10.69
(27.1)
A
610
(155)
7.78
(198)
C
B
7.55
(192)
2
4.19
(10.6)
8.12
(20.6)
1. Water fill is 3/8 (1.0) tubing connection on left back of left controls.
2. Main drain is ¾ female NPT.
OUTSIDE DIMENSIONS
MODEL
A B
SM50EZ 10.34" 8.38"
WELL (26.3) (21.3)
Description: Lever Operated Drain Valve
MODEL
VOLTS
SM50EZ WELL 208/240
NOTE: CUT-OUT SIZES ARE DIFFERENT FROM STANDARD APW HOT FOOD WELLS (HFW'S)
OPERATION
1. Follow General Operating Instructions on page 3.
Soup Well
Cut-out
6.0 (15.2) Minimum
From Counter Edge 2.0 (5.1) Minimum
From Counter Top
G
Control Cut-Out
GENERAL SPECIFICATIONS (APW EZFILL HOT FOOD WELLS)
INSIDE DIMENSIONS
C E
6.44" 8.32"
(16.4) (21.1)
Stock Number: 56360
ELECTRICAL SPECIFICATIONS
ELECTRICAL RATINGS 500 EA. @ 208V / 660 EA. @ 240V
WATTS
500/660
1. F o l l o w g e n e r a l i n s t a l l a t i o n
2. Make applicable Cut-Out per above
3. Apply putty tape to the underside
D
4. Apply a 1/4" (.6) bead of silicone
5. Drop well into opening from the top
6. From below the counter surface
F
7. Trim excess putty and sealant from
8. Mount control to front panel using
9. Check nameplate for proper voltage.
10. Connect overflow tube on hot food
CUT-OUT
D
10.875
(27.6)
OPTIONS
Drain Manifold: Fabricated to Unit, Required
AMPS (1 Phase)
2.4/2.75
1. Follow General Cleaning Instructions on page 3
4
INSTALLATION
instructions on page 3.
table. Note: Unit is designed for
installation in stainless steel tops.
Optional wood mounting kit available.
perimeter of the well rim outer edge.
sealant adjacent to the putty tape on
the well flange.
and push down until entire
parameter of rim is flush with the
counter surface.
insert an 8" to 10" (20 to 25 cm) flat tip
screwdriver into the locking ring tab
slots and twist in a clockwise motion
to lock well in place.
around well rim.
hardware. Maintain 4" (10.2)
clearance between well and front
panel.
Connect power.
well to suitable tubing to handle
212°F water. Run to open drain.
Note: Electrically connect units to
comply with local and NEC codes.
CONTROL CUT-OUT
F G
5.0 12.5
(12.7) (31.8)
MAX AMPS (3 PHASE)
N/A
CLEANING
SHIP WT.
13 Lbs.
(5.9 Kg)