HDMI CLEAN SWITCH – MODEL: CLN-SW-6x1-H Copyright and Trademarks: All rights reserved by APANTAC LLC, Portland, Oregon, USA. No part of this document may be reproduced in any form or by any means without written permission from the product manufacturer. Changes are periodically made to the information in this document.
HDMI CLEAN SWITCH – MODEL: CLN-SW-6x1-H What’s In The Box? HDMI Clean Switch, Model: CLN-SW-6x1-H RS232 Communication Connecting Cable Power Cord Power Adapter HDMI Cable Remote Control User Manual HDMI Matrix Software CD Rack Ear Screws 2 Rack-Mount Brackets...
HDMI CLEAN SWITCH – MODEL: CLN-SW-6x1-H 4.0.3: Rear Panel Figure 4-2: CLN-SW-6x1-H Rear Panel 1. Power: 12V DC 3A 2. HDMI 1 ~ 6: 6 HDMI inputs HDMI Type A Connector Pin Definition: Pin # Signal Pin # Signal TMDS Data2+...
Page 9
• DIP Switcher Pin 1: Reset the web server IP address to 192.168.0.3. The steps are as below: o Please adjust the pin1 to ON and re-start the CLN-SW-6x1-H Switcher o After the HRM-602P Switcher re-starts about 10 seconds, shut down your equipment.
5.0.1 Switch Control Connection Use the supplied RS232 cable to connect the computer’s serial port (COM1 or COM2) to the RS232 port of the CLN-SW-6x1-H to enable remote control via serial interface. Figure 5-1 (a): RS232 and Control PC connection CLN-SW-6x1-H also supports a LAN port that allows you to control the switch through a browser.
Page 11
HDMI CLEAN SWITCH – MODEL: CLN-SW-6x1-H Figure 5-2 (b): LAN port and Control PC Connection APANTAC LLC ● 7470 SW Bridgeport Road, Portland, OR 97224 USA PHONE +1 503 986 3000 ● FAX +1 503 389 7921 ● INFO@APANTAC.COM ●...
HDMI CLEAN SWITCH – MODEL: CLN-SW-6x1-H 5.0.2 IR Connection The CLN-SW-6x1-H can also be controlled via an IR remote control simply by connecting the IR port on the rear panel. Figure 5-4: IR Connection The CLN-SW-6x1-H supports a remote controller, which allows remote switching with an IR remote control.
Page 15
HDMI CLEAN SWITCH – MODEL: CLN-SW-6x1-H Channel A Selection: Press the Number#1~6 button to select the inputs on Channel A. Channel B selection: Press the “0” + Number#1~6 button to select the inputs on Channel B. Example: Press the “0” on the Remote first, then press the “3” to select input 3 on...
Need help?
Do you have a question about the CLN-SW-6x1-H and is the answer not in the manual?
Questions and answers