Safety Instructions - Strait-line Laser Level Owner's Manual

This tool emits a laser beam, which, when used indoors, generates a
visible straight line on the surface on which the tool is placed.
This is a Class IIIA (U.S. version) or IIIR (Europe version) laser tool and is
manufactured to comply with international safety rule IEC 285.

SAFETY INSTRUCTIONS:

Failure to follow warnings may result in bodily injury.
WARNINGS:
Class IIIA Laser Product
Laser radiation emitted from tool
Max. Power Output < 5mw
Wavelength: 630-660 nm
Do Not Stare Into Beam
AVOID DIRECT EYE EXPOSURE
THIS TOOL EMITS A LASER RADIATION
This caution notice is reminded with a sticker located on one side of the unit.
Page 1
DANGER
IMPORTANT: Read all instructions prior to operating this tool and
DO NOT remove any labels from the tool.
CAUTION – Use of controls or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
The power of the emission of the laser beam exceeds 1mW in Class II
and is less than 5mW in Class IIIA (U.S. version), so the following
warnings must be followed to avoid injury:
DO NOT stare directly at the laser beam.
DO NOT project the laser beam directly into the eyes of others.
DO NOT set up the tool at eye level or operate the tool on or near a
reflective surface, as the laser beam could be projected into your eyes
or the eyes of others.
DO NOT push the metal pins into material other than drywall
or soft wood as breakage of the pins and/or the tool may occur.
To avoid injury, ALWAYS make sure the pins are fully retracted before
handling or storing the tool, and keep the tool out of reach of children
and other untrained persons.
ALWAYS turn the laser off when it is not in use or is left unattended for
a period of time. Remove the batteries when storing the tool for an extended
time to avoid damage to the tool should the batteries deteriorate.
Page 2