Page 1
Programming Alinco -135T, 235T, and 435T VHF/UHF Radios RADIO DISPLAYS and CONTROLS: The front panel of the radio is shown in Figure 1. Figure 1 Turning The Radio On: The power switch is the pushbutton in the upper right hand corner of the radio.
Page 2
On the Alinco, you push the V/M function key to terminate or close function selection. SIMPLEX OPERATION: Simplex is the simplest mode of operation. Simplex does not involve a repeater and is used to communicate with a “near by” ham who is approximately in your line of sight.
Page 3
A good level to start with is Medium. On the Alinco, H/L (High/Low power) is displayed above the CALL key. This means that power selection is a second level function. Push the Function (FUNC) key followed by the CALL key to select power level.
Page 4
frequency from 67.0 to 250.3 Hz. A repeater will only retransmit signals which contain its particular PL tone. For example, the PL for Bozo is 127.3 Hz while that for Grissom is 94.8 Hz. To utilize a repeater, your radio must be programmed to transmit the PL tone which the repeater is expecting.
Page 5
Writing to a Memory Channel: Storing the information that you have programmed into the VFO is particularly easy on the Alinco radio. Push the V/M key to place the radio in the memory mode. An M will appear on the left edge of the display. Turning the Tuning Knob will select different memory channels.
Page 6
To name a memory channel proceed as follows. In the memory read mode, select the channel that you want to name. Push the FUNC key for more than 2 seconds. Repeatedly push the SQL function key to cycle through the various set up functions. Stop when the letter A appears flashing on the screen.