Wheels And Tires - Ford FOCUS Owner's Manual

A Protective cap
B Pressure relief valve
C Hose
D Orange cap
E Bottle holder
F Pressure gauge
G Power plug with cable
H Compressor switch
I Label
J Bottle lid
K Sealant bottle
1. Open the lid of the tire repair kit.
Focus (CB8) Vehicles Built From: 03-03-2014, Vehicles Built Up To: 31-12-2014, CG3568en enGBR, Edition date: 03/2014, None

Wheels and Tires

2. Peel off the label I showing the
3. Take the hose C and the power plug
4. Unscrew the orange cap D and the
5. Screw the sealant bottle K clockwise
6. Remove the valve cap from the
7.
8. Make sure that the compressor switch
9. Insert the power plug G into the cigar
10.
11.
12.
Note: When pumping in the sealant through
the tire valve, the pressure may rise up to
6 bar (87 psi) but will drop again after about
30 seconds.
Note: After you have switched the
compressor off, you may hear air escaping
from the damaged tire. This is normal and
can be ignored provided that the specified
minimum tire pressure has been reached.
221
maximum permissible speed of
80 km/h (50 mph) from the casing and
attach it to the instrument panel in the
driver's field of view. Make sure the
label does not obscure anything
important.
with cable G out of the kit.
bottle lid J.
into the bottle holder E fully tight.
damaged tire.
Detach the protective cap A from the
hose C and screw the hose C firmly
onto the valve of the damaged tire.
H is in position 0.
lighter socket or auxiliary power socket.
See Cigar Lighter (page 116). See
Auxiliary Power Points (page 116).
Start the engine.
Move the compressor switch H to
position 1.
Inflate the tire for no longer than 10
minutes to an inflation pressure of
minimum 1.8 bar (26 psi) and a
maximum of 3.5 bar (51 psi). Move
the compressor switch H to position
0 and check the current tire pressure
with pressure gauge F.