Table of Contents
Advertisement
Caution
To prevent electrical shock do not use the electrical plug of your Totem Subwoofer with an extension
cord, receptacle or other outlet unless the blades can be fully inserted to prevent exposure. To
protect against the risk of electrical shock do not use near bathtubs, sinks, swimming pools, saunas,
in wet basements, near other water sources, or rain. If service is required, please refer to your
Totem Authorized Dealer.
amplifier module Controls
Figure 1: Front Panel
1 Input level attenuator
This control is used to alter the signal level entering the amplifier or to cut down the unwanted noise
from the input signal.
2 Crossover frequency adjustment
Continuously variable from 40Hz - 120Hz, to allow custom integration with any Totem loudspeaker.
Turning the dial completely to the right will bypass the crossover.
3 Phase control
Continuously variable from 0° - 180° to allow custom integration with mid/high units in various
installation positions.
4 Crossover / Bypass switch
Allows the low pass crossover to be taken out of the circuit so an external crossover can be used
5 On/Auto switch
In the auto position the amplifier will go into sleep mode when there is no signal present for 20-30
minutes. On position defeats the sleep mode.
6 Power indicator
This blue LED indicates that there is power present at the amp and that the rear mounted power
switch is on.
totemacoustic.com
7
Advertisement
Table of Contents
