Page 1
We hope you not only enjoy but experience Totem as your guide to a new and rewarding listening environment! You will without a doubt experience a Totem moment.
Page 2
The Totem limited warranty applies to products in normal home use only. The warranty is void if serial numbers have been altered or removed. The warranty is void if products show signs of abuse. The warranty is void if the speakers have been tampered with.
Congratulations on your new Totem subwoofer: Thunder II Sub. A reference sub designed to seamlessly blend with your Totem speakers in any stereo or home theatre application. Please take the time to fully read this manual prior to beginning set-up. The manual will clearly guide you to achieve the best possible sound that these newly acquired Totem speakers are capable of providing.
produCt features / speCifiCations • 10 inch subwoofer, cast frame, rubber surround • Externally identical double passives • Built in 300 watt peak RMS high efficiency amplifier • Adjustable (40 to 150Hz) Low-pass crossover • Line level (RCA) inputs • Signal sensing auto turn/off button •...
Page 5
Filename:Totem500PanelSilkRevF.cdr 1 color: White Silkscreen p/n: SLK2189 Revision: F 4.0A 120V~ 60Hz POWER V O L CAUTION: FOR CONTINUOUS PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE AND RATING ATTENTION: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE P H A S E ET CALIBRE 4.0A 250V...
(including amplifiers) that produce heat. 7- To protect the Totem Dreamcatcher Sub, avoid microphone feedback, continuous and excessive output from electronic musical instruments or excessive signal distortion.
Page 7
95 hours. use the PHASE dial and or switch to adjust the phase of the Totem subwoofer to your main speakers. When in phase the system will give a much fuller bass response. If your main speakers become brighter then usual it means the system is out of phase and needs readjusting.
Connect the power cord to the A.C. power inlet on your subwoofer and then directly to the A.C. receptacle on the wall. Turn the unit on. Note: The Totem Thunder II is available for 120 V and 230 V operation. Make sure you have the right unit before connecting it to the A.C. supply. totemacoustic.com...
100 hours. use the PHASE dial to adjust the phase of the Totem Thunder II subwoofer to your main speakers. When in phase the system will give a much fuller bass response. If your main speakers become brighter then usually it means the system is out of phase and needs readjusting.
Page 10
When using the Thunder II in a home cinema setup it is recommended to place it in a corner. The corner location offers the greatest output levels and optimum low frequency extension.