Toshiba MMY-MAP0724FT9UT Owner's Manual page 12

3
Push the SWING/FIX button to confirm the
direction of the selected louver.
Each time the button is pushed, the indication
changes as follows:
(1) (2) (3) (4)
(7) (6) (5)
* When cooling or drying, (4) and (5) are not
displayed.
◆ Setting the swing pattern
1
SWING/FIX FIX for at least 4
Push and hold the
seconds while the operation is stopped.
blinks.
2
Push the UNIT LOUVER button (left side of the button)
to select a unit.
The unit number changes each time the button is
pushed.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
No Unit No.
display 1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the buttons to select a swing
type.
Swing code
Swing code Movement pattern
Standard swing
0001
(factory default)
0002 Dual swing
0003 Cyclic swing
REQUIREMENT
Do not set "0000".
(The louver may be damaged.)
21-EN
4
Push the button.
5
Push the button to finish the setting.
▼ Standard swing
All four louvers swing simultaneously at the same
angle.
Swing
▼ Dual swing (Recommended for heating)
• Adjoining louvers alternately point horizontally and
downward to heat the room evenly.
• Air blown downward reaches the floor, and air blown
horizontally is spread to circulate heat.
Horizontal
Horizontal
Downward
Downward
Horizontal
Horizontal
Downward
Downward
– 11 –
▼ Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
(2)
(3)
(1)
(4)
(2)
(4)
(1)
(3)
(1)
(2)
(4)
(3)
(2)
(1)
(3)
(4)
◆ Setting the louver lock
1
Push and hold the UNIT LOUVER button (right side of
the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the UNIT LOUVER button (left side of the button)
to select a unit.
The unit number changes each time the button is
pushed.
Unit No. Unit No. Unit No.
1-1 1-2
Unit No.
1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP.
display the number of the louver to fix its
direction.
The selected louver swings.
4
Push the buttons to select the
direction of the louver you do not want to
swing.
(1) (2)
0001 0002
(4)
(5)
0004
0005
* If (4) or (5) is selected, condensation may occur
during cooling.
Electrical control box
03
Refrigerant
pipe
04
Drain pipe
01
5
Push the button to confirm the setting.
When the setting is confirmed, the
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
1-3
" buttons to
(3)
0003
02
mark lights
22-EN