Water Supply To Icemaker - GE TFHA22R Use And Care Manual

Rollers
Adjustable rollers behind the base grille enable you to
move the refrigerator away from the wall for cleaning.
These rollers should be set so the refrigerator rests
automatically from a halfway-open position, there is a
built-in tilt from the front to the back of the cabinet.
Side-by-side refrigerators also have specially designed
door hinges that lift both doors slightly when opened,
allowing the force of gravity to help close them securely.
To adjust rollers, remove
the base grille by grasping
it at the bottom and pulling
Turn roller
screws clockwise to raise
refrigerator, counterclockwise to lower it. Use
adjustable wrench (3/8" hex head bolt) or pliers.

Water Supply to Icemaker

You will need to connect your icemaker to a cold water line. A water supply kit containing copper
tubing, shut-off valve, fittings and instructions is available at extra cost from your dealer. There
should be sufficient tubing for the icemaker from the cold water supply to allow you to move the
refrigerator out from the wall several feet (approximately 8 feet of 1/4" copper tubing in three
10-inch diameter coils.)
14
(continued)
When adjusting front rollers
for proper door closure, we
recommend that the bottom
front edge of the cabinet be
approximately 5/8" from the
floor.
To replace base
grille, align prongs
on back of grille
with clamps in
cabinet and push
forward until grille
snaps into place.