Table of Contents
Advertisement
5 - SET-UP FOR OPERATION
Fig. 4
3
2
6
4
5
1
7
5.3.10 Heating elements of electric oven GN 2/1
Unplug the appliance from the electrical mains!
The lower heating elment (pos. 1 fig. 5) is placed under the bottom.
The upper heating elment (pos. 2 fig. 5) element is attached to the
top of the cooking chamber.
To remove the heating elements, unscrew the screw that attach
themto the corresponding flange, pull the heating elements and
relative wires forward.
Use a screwdriver to disconnect the wires and install a new heating
element in reverse order.
5.3.11 Heating element of electric oven GN 1/1
Unplug the appliance from the electrical mains!
To remove the heating element (pos. 6 fig. 6), remove the rear bulk-
head, unscrew the screws fixing the the heating element to the
oven, pull the heating element forward with relative wires.
Disconnect the wires, and install a new heating element in reverse order.
5.3.12 Fan of of electric oven GN 1/1
Unplug the appliance from the electrical mains!
To replace the fan remove the back unscrew the sight screws, discon-
nect the wires from the motor, from the inside of the chamber
remove the rear bulkhead fan cover and the fan (pos. 1 fig. 6) by
loosening the locking nut (pos. 2 fig. 6 "NB. the nut is with left
thread").
Loosen the bolts (pos. 3 fig. 6) hat hold the motor (pos. 4 fig. 6) on
the oven and pull off from rear. Re-install in reverse order position-
ing in the correct way the seal protection (pos. 5 fig. 6) and power
mains.
0803_GB_42 - GAS KITCHENS WITH PILOT
04/2008
14 · 20
Advertisement
Table of Contents
