Table of Contents
Advertisement
WARNING
CAUTION
INSTALLING THE DOOR CONTROL
1
Strip Door Control
Wire
Strip
7/16" (11 mm)
Insulation
A21
Door Control
Button
Terminal
Screws
3
Position Door Control, Route Door Control Wire to
Motor Unit and Secure with Insulated Staples.
Permanently Mount 2 Safety Labels Using Adhesive
Backing, Tacks or Staples, If Necessary.
5
Attach Door Control to Wall and Replace Cover
Multi-Function Door Control
Door Control Button
C12
Screw
C15
C12
Drywall
Screw
Anchors
Multi-Function Door Control:
If, No Gang Box is Present
C12
Screw
2
Connect Wire to
Door Control
Wire
A6
Door Control:
White
Multi-Function
Wire
Red/White
Wire
Red/White Wire
C15
Drywall
Anchors
OR
C12
Screw
ALL HARDWARE SHOWN ACTUAL SIZE
C15
Drywall Anchors
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is not connected BEFORE installing Door
Control.
• Connect ONLY to 24 VOLT low voltage circuit.
To prevent possible SERIOUS INJURY or DEATH from a closing
garage door:
• Install Door Control within sight of garage door, out of reach
of children at a minimum height of 5 feet (1.5 m), and away
from all moving parts of door.
• NEVER permit children to operate or play with door control
push buttons or remote control transmitters.
Terminal
• Activate door ONLY when it can be seen clearly, is properly
Screws
adjusted, and there are no obstructions to door travel.
White Wire
• ALWAYS keep garage door in sight until completely closed.
NEVER permit anyone to cross path of closing garage door.
C1
Insulated
Door Control
Staple
Wire
5 FEET (1.5 m)
MINIMUM
Do NOT strip any
insulation from
the staples
Single
C13
Gang Box
Screw
C13
Screw
Multi-Function Door Control:
Gang Box Installation
C13
15
WARNING
WARNING
4
Carefully Remove Cover
Multi-Function Door
Controls ONLY
C1
Insulated Staple
6
Connect Door Control Wires
to Motor Unit
24V Circuit
KG
Screw
Red
Terminal
Red/White
White
Wire
Terminal
White
Wire
24V Circuit
KG
Antenna
C1
C1
Insulated Staples
Staples
Advertisement
Table of Contents
