Position And Hang Motor Unit - Power Drive PD210D Assembly And Installation Manual

POSITION AND HANG MOTOR UNIT

1
Open Door to Full Open Position and Rest Rail
on a 2x4 to Position Opener at the Proper
Angle for Hanging from the Ceiling
2
Attach Hanging Brackets to Ceiling and Fasten Motor Unit to Hanging Brackets
NOTE: Before the motor unit is secured to the ceiling, insure that the motor unit and rail are centered
over the door. If you mounted the header bracket off center, hang the motor unit the same distance.
Concrete anchors must be used if installing any brackets into masonry.
Option with finished or unfinished ceiling
Bracket
(Not Provided)
C9
Hex Bolt
C5
Lock Washer
C4
Nut
3
Remove 2x4 and Close Door
C8
Lag Screw
2 x 4
C8
Lag Screws or
Concrete Anchors (Not Provided)
(Not Provided)
Bolt 5/16"-18 x 7/8"
Lock Washer 5/16"
Nut 5/16" - 18
Close door
ALL HARDWARE SHOWN ACTUAL SIZE
C9
Hex Bolt
WARNING
WARNING
To avoid possible SERIOUS INJURY from a falling garage door
opener, fasten it securely to structural supports of the garage.
CAUTION
CAUTION
To prevent damage to garage door, rest garage door opener
rail on 2 x 4 placed on top section of door.
If the top section or panel hits the trolley when you
raise the door, pull down on the trolley release arm to
disconnect inner and outer sections. Slide the outer
trolley toward the motor unit. The trolley can remain
disconnected until installation is completed.
NOTE: The garage door opener motor head will
typically sit lower than the header bracket, therefore,
the rail will be at an angle.
Option with unfinished ceiling
OR
Measure
Distance
C9
Hex Bolt
C5
Lock Washer
C4
Nut
Remove
2 x 4
C4
12
C8
Lag Screws
C5
Nut Lock Washer