Replacing The Contact Points - Einstein E-collar 400TS Owner's Manual

24

REPLACING THE CONTACT POINTS

The standard 5/8" contact points are used for most dogs.
Thicker fur breeds require the longer 3/4" contact points.
Replace the 5/8" contact points by following the instructions
below using the enclosed contact point tool.
1. Loosen both contact points by rotating the contact point
counter-clockwise using the contact point tool.
2. Install the 3/4" contact points onto the bolt and tighten the
contact points by rotating them clockwise with the contact point
tool.
* For short haired breeds such as boxers, dachshund, pit bulls, etc,
please contact customer service and get the micro-probe contact points.
Einstein Owner's Manual 400TS