Removing And Installing The Bobbin; Removing The Bobbin Case - Strongarm Walking Foot Sewing machine User Manual

The bobbin will automatically stop winding when it is full. If you're doing a big job, it's a good idea
to wind all bobbins before you start to save unthreading the machine. Best of all is to have two
spools of thread, one for sewing and the other for winding bobbins as you sew. This will require
the purchase of a second thread stand.
The bobbin can be accessed through the machine's black sliding cover plate to the left of the
needle.

Removing the bobbin case

Slide the cover-plate to your left and grab the small lever on the bobbin with your thumb
and forefinger.
Pull the bobbin case out from the machine. You'll notice with the lever out, the bobbin is
captive inside the bobbin case.
One you release the lever, the bobbin is free to be removed from the bobbin case.
3. Run the thread back again through the lower hole in the bobbin post
this time
4. Bring the thread under and up through one of the holes on the
higher side of the empty bobbin and hold the end of the thread
to give a small amount of tension.
5. Click the bobbin to the right
6. Press the foot pedal to wind the thread onto the bobbin.

Removing and installing the bobbin