How To Mount The Powerwheel - Strongarm Walking Foot Sewing machine User Manual

How To Mount The Powerwheel

1. Unscrew and remove the stop
m o t i o n s t o p s c r e w w i t h a
screwdriver
2. By hand, unscrew and remove
the stop motion screw
3. Remove clamp washer from
under the stop motion screw
4. Remove the drive belt cover held
by two screws.
5. Remove longer main belt, turn
hand wheel to assist removal.
6. Remove the hand wheel, wheel
slides off.
7. Install the Powerwheel on the end
of the shaft making sure that the
teeth on the wheel are facing the
sewing machine
8. On the Powerwheel there are two
small holes, under the belt on the
bevelled side. Insert the two grub
screws into the holes, and tighten
using the 1/8" Allen key provided.
9. Install the new drive belt. Slip the
drive belt over the Powerwheel
first and then slip the belt over the
small idle pulley at the back.
10. Put back in place the stop motion
screw and clamp motion washer.
Put back in place the stop motion
clamp stop screw.
11. Put the new belt cover on with
two screws.
12. For hand crank only, install the
handle to the Powerwheel by
tightening the Allen screw with the
5/32" Allen key provided.