Tools And Accessories Case - Strongarm Walking Foot Sewing machine User Manual

Unpacking and Setting Up Your Strongarm
Sewing Machine.
Remove the tools and accessory box and the thread stand that are taped to the foam
packing surrounding the sewing machine.
Fit the base to the machine. It's a job best done by two people, or by laying the machine
on the edge of a table. The base has two pins that insert into two holes on the back of
the sewing machine.
Slide the two pins on the base into the holes in the back of the sewing machine. The
two holes have small screws on their underside that may need to be loosened using the
screw driver supplied in the tools and accessory case. Once the pins are located in the
holes, tighten the screws to secure the base to the machine. The base can now be
swung under the machine. If the base doesn't line up properly, loosen the screws to
adjust the position of the base, then re-tighten.
There is a small tab on the front right of the sewing machine that locks the base in
place.
Please retain the original foam and cardboard shipping container. You'll need it if you
ever need to transport the machine or return it for service

Tools and Accessories Case

Inside the tools and accessory case you'll find the thread post. It's a small silver rod
about 5cm long with two holes.
The thread post screws onto the top of the machine just in front of the carry handle.
The thread stand is taped to the foam packaging. To assemble, screw the smaller rod
into the centre of the base. Loosen the small screw on the side with the supplied
screwdriver. Insert the thread guide into the hole and then tighten the screw.