Philips xxHFL5xx9 series User Manual page 30

Antenna (DVB-T) or Cable (DVB-C) and press OK.
4 - Select the DVB setting you want.
5 - Press , repeatedly if necessary, to close the menu.
DVB-C channel installation
For ease of use, all DVB-C settings are set to automatic.
If your DVB-C provider gave you specific DVB-C values, the
network ID or network frequency, enter these values when the
TV asks for them during installation.
It might be necessary to adjust the scanning (full or quick scan)
or enter a specific symbol rate in the Settings menu while
installing. To set a Symbol rate, first set the Symbol rate to
Manual.
Channel number conflicts
In some countries, different TV channels (broadcasters) might
have the same channel number. While installing, the TV shows
the list with channel number conflicts. You need to select which
TV channel you want to install on a channel number with
multiple TV channels.
DVB-T + DVB-C
If you can use a DVB-T antenna input but also a DVB-C input,
you can set up your TV for both DVB-T and DVB-C. Install one
system followed by the other with the necessary settings.
Once each system is installed, you need to switch the antenna
input signal on the Antenna connection on the back of the TV
and set the TV in the appropriate system to view the installed
channels on TV.
To select the DVB-T or DVB-C setting, see above.
DVB settings
Access DVB settings
1 - Professional Mode: Off  Press  and select Setup and
press OK.
Professional Mode: On  Enter the Professional Home Menu.
2 - Select Search for channels and press OK.
3 - Select Re-install Channels.
4 - Select the country where you install this TV.
5 - Select Cable (DVB-C).
6 - Select Start to search channels, or select Settings for DVB-
C settings.
7 - Press  , repeatedly if necessary, to close the menu.
Symbol rate mode
If your cable provider did not give you a specific symbol rate
value to install the TV channels, leave the Symbol rate mode
setting on Automatic.
If you received a specific symbol rate value, select Manual.
However, the value you received could be in the predefined list
of symbol rates already. Select Predefined symbol rates to
check if your value is available automatically.
Predefined symbol rates
With the Symbol rate mode set to Automatic, the TV will use 1
of the predefined symbol rates as used by most cable providers
in your country.
Symbol rate
With the Symbol rate mode set to Manual, you can enter the
symbol rate value you received from your cable provider. To
enter the value, use the number keys.
Symbol rate 2
With the Symbol rate mode set to Manual, you can enter a
second symbol rate value you received from your cable
provider. To enter the value, use the number keys.
Network frequency mode
If you intend to use the fast Quick scan method in Frequency
scan to search for channels, select Automatic. The TV will use 1
of the predefined network frequencies (or HC - homing
channel) as used by most cable providers in your country.
If you received a specific network frequency value to search for
channels, select Manual.
Network frequency
With the Network frequency mode set to Manual, you can
enter the network frequency value received from your cable
provider here. To enter the value, use the number keys.
Frequency scan
Select the method of searching for channels. You can select the
faster Quick scan method and use the predefined settings used
by most cable providers in your country.
If this results in having no channels installed or if some channels
are missing, you can select the extended Full scan method. This
method will take more time to search for and install channels.
Frequency step size
The TV searches for channels in steps of 8MHz.
If this results in having no channels installed or if some channels
are missing, you can search in smaller steps of 1MHz. Using the
1MHz steps will take more time to search for and install
channels.
30