Toshiba RAS-22SKV2-A1 Service Manual page 44

Note:
• Keep the remote controller in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
• The setting will be saved for the next same operation.
9. PRESET OPERATION
Set your preferred operation for future use.
The setting will be memorized by the unit for future operation (except air flow direction).
1. Select your preferred operation.
2. Push and hold
3. Push PRESET : Operate the preset operation.
10. AUTO RESTART OPERATION
To automatically restart the conditioner after the power failure (Power of the unit must be on.)
Setting
1. Push and hold the RESET button on the indoor unit for 3 seconds to set the operation.
(3 beep sound and OPERATION lamp flashes 5 time/sec for 5 seconds)
• Do not operate ON timer and OFF timer.
2. Push and hold the RESET button on the indoor unit for 3 seconds to cancel the operation.
(3 beep sound but OPERATION lamp does not flash)
11. QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
Push QUIET : Start and stop the operation.
Note:
Under certain conditions, QUIET operation may not provide adequate cooling or heating due to low sound
features.
12. COMFORT SLEEP OPERATION
To save energy while sleeping, automatically control air flow and automatically turn OFF.
Push COMFORT SLEEP : Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note:
The cooling operation, the set temperature will increase automatically 1 degree/hour for 2 hours
(maximum 2 degrees increase). For heating operation, the set temperature will decrease.
13. SLEEP TIMER OPERATION
To start the sleep timer (OFF timer) operation
Push SLEEP : Select 1, 3, 5 or 9 hrs for OFF timer operation.
PRESET for 3 seconds to memorize the setting. The
– 44 –
FILE NO. SVM-12002
mark displays.