Quiet Mode; Comfort Sleep; Short Timer - Toshiba RAS-22SKV2-A1 Service Manual

Item Operation flow and applicable data, etc.

14. QUIET mode

When the [QUIET] button is pushed, the fan of
the indoor unit will be restricted the revolving
speed at speed L - until the [QUIET] button is
pushed once again (cancel Quiet mode).
15. COMFORT Cooling mode
SLEEP
• The preset temperature will increase as
shown on ECO operation (Item No. 9)
• Push the [COMFORT SLEEP] button to
choose the operating hours.
Repeat pushing to select the hours.
(1hr, 3hr, 5hr or 9hr)
• If the [COMFORT SLEEP] button is pushed
again means cancel comfort sleep mode.
Heating mode
• The preset temperature will drop down as
shown on ECO operation (Item No. 9)
• Push the [COMFORT SLEEP] button to
choose the operating hours.
Repeat pushing to setect the hours.
(1hr, 3hr, 5hr or 9hr)
• If the [COMFORT SLEEP] button is pushed
again means cancel comfort sleep mode.

16. Short Timer

In the normal condition, after switching one
circuit breaker, 3-minute delay time for
compressor and 1 hour for plasma air purifier
are set for the maintenance of the unit.
PRESET FAN
TEMP
ONE-TOUCH MODE
COMFORT
QUIET PURE SLEEP
SWING FIX Hi-POWER ECO
TIMER CLR
ON OFF
SLEEP SET
CHK FILTER CLOCK
Quiet mode is the system which, control the
revolving speed of indoor fan to work constantly
at lower than speed L. In addition, noise level of
indoor unit is less than usual.
Remarks :
1. Quiet mode is unable to work in dry mode.
2. Quiet mode is appropriate to work with less
cooling load and less heating load condition.
Because of the fan speed L- may cause not
enough the cooling capacity or heating
capacity.
The principles of comfort sleep mode are:
• Quietness for more comfortable. When room
temperature reach setting temperature
• Save energy by changing room temperature
automatically.
• The air condition can shut down by itself
automatically.
Remarks:
1. Comfort sleep mode will not operate in dry
mode and fan only mode.
Purpose
To start the unit immediately for the purpose of
testing, trial...etc, short timer can be used.
maintenance of the unit.
Short Timer Setting
Q
Push [
R
Set the operation mode or plasma air purifier
on the remote controller without sending the
signal to the unit.
S
Use the tip of the pencil to push the [CHK]
button and hold, "00" will show on display,
then push [SET] button to make "00" disap-
pear.
T
Push [
U
When short timer is activated, all setting on
4
the remote controller operates immediately,
besides, all indicatiors on front panel turn ON
continuously for 3 seconds.
3
– 38 –
FILE NO. SVM-12002
Description
] button to turn the unit OFF.
] button to turn the unit ON.