Setting Up The Network Controller Hardware; Connecting A Network Controller - Honeywell Internet Connection Module Setup Manual

Setting up the Network Controller Hardware

Connecting a Network Controller

To connect an ICM:
Figure 1 - ICM connections
1. Place the ICM in a suitable clean, dry, ventilated indoor location, near the
equipment to be controlled.
a. The RS-232 standard for serial communication limits serial cables to 50
feet in length; Keep the ICM within 50 feet of the device it will control.
b. The ICM is not designed to be installed in an attic, crawl space, or an
outdoor location.
2. Connect the controlled device to the ICM using the RS-232 cable recommended
by the manufacturer. The ICM uses exactly the same cable you would use to
connect the device to a PC (DB-9 connector).
3. Connect the Ethernet port on the ICM to the network hub or switch using a
standard CAT5 cable.
4. Plug the included 12 Volt 300mA power supply into a suitable power outlet.
Technical Support Setup - Guide
- Page 7 of 18 -