Setting Up The Refrigerator - Samsung RS25H50 Series User Manual

When moving your refrigerator
To prevent floor damage, be sure the front leveling
legs are in the up position (above the floor).
Refer to 'Leveling the refrigerator' in the manual
(page 14).
CONTROL LEVER
Flooring
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the finish of the flooring during
installation, cut a large section of the cardboard
carton and place it under the refrigerator where
you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back.
Do not wiggle it from side to side.
CAUTION
When installing, servicing, or cleaning behind the
refrigerator, be sure to pull the unit straight out and
push back in straight after finishing.
DA68-02981E-01.indb 10
SCREW DRIVER(-)
English - 10
Important: Make sure that you can easily move
your refrigerator to its final location by measuring
doorways (both width and height), thresholds,
ceilings, stairways, etc.
• Make sure you disconnect the water supply line
BEFORE removing the freezer door.
To avoid damage, refer to 'Separating the water
line from the refrigerator' in the manual (page
12).

SETTING UP THE REFRIGERATOR

Installing the handles
Important : If you need to remove the refrigerator's
doors to move it into place, install the handles after
you put the doors back on.
Take the handles out of the right side door.
The handles are included in the box.
Fixer screw quantity is optional.
14. 1. 20. 7:48