Download Print this page

Packing List; Trimming Instructions - EarthWise HT10022 Operator's Manual

22"/24" electric hedge trimmer

Advertisement

GENERAL
CHECK DAMAGED PARTS
Before further use of the hedge trimmer, a
guard or other part that is damaged should be carefully checked to deter­
mine that it will operate properly and perform its intended function, Check
for alignment of moving parts, binding of moving parts, breakage of parts,
mounting and any other condition that may affect its operation. A guard or
other part that is damaged should
be
properly repaired or replaced by an
authorized service center unless otherwise indicated elsewhere in this
manual.
LIGHTING Only operate trimmer in daylight or good artificial light.
DON'T OVERREACH
Keep proper footing and balance at all times.
!
WARNING: Do Not use the hedge trimmer with any type of accessory or
attachment. Such usage might be hazardous.
POLARIZED PLUGS - To reduce the risk of electric shock, this equipment
has
a
plug (one blade is wider than the other). This equipment must
be
with
a
suitable polarized 2 wire or 3 wire extension cord. Polarized
connections will fit together only one way. Make sure that the receptacle end
of the extension cord has large and small blade slot widths, If the plug does
not fit fully into the extension cord, reverse the plug, If it still does not fit, ob ­
tain a suitable extension cord. If the extension cord does not fit fully into the
outlet, contact
a
qualified electrician to install the proper outlet. Do not change
the tool plug or extension oord in any way.
WARNING: Some dust created by this product contains chemicals known to
the State of California to cause cancer, birth defects or other reproductive
harm, Some examples of these chemicals are:
-compounds in fertilizers
-compounds in itlSecticides, herbicides and pesticides
-arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety equip ­
ment such as dust masks that are specially designed to filter out microscopiC
particles.
PACKING LIST
Hedge Trimmer
Blade Cover - Instruction Manual
WARNING: Do not connect to power supply until assembly is
Failure to comply could result in accidental starting and possible
personal injury.
_L
WARNING: If any parts are damaged or missing do not operate this product
until the parts are replaced. Failure to heed this warning oould result in
serious personal injury.
UNPACKING
This product requires no assembly.
Carefully remove the product and any accessories from the box. Make sure
that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage occurred
during shipping.
Do not discard the packing material until you have carefully inspected and
satisfactorily operated the product
If any parts are damaged or missing, please call 1-800-313-5111
for assistance.
TO TURN THE TOOL ON
Push the lock button in with your thumb and then squeeze the trigger with
your fingers. (Once the tool is running, you can release the lock button), To
turn the tool OFF, release the t'igger.
CAUTION: Blade ooasts after turned off,
Do not use under wet conditions.
Do not use with damaged extension cord.
Do not unplug or store with switch locked on.
WARNING: To guard against injury, observe the following:
Read instruction manual before using, save instruction manual.
Keep hands away from blades.
Keep hands on handles, Don't overreach.
WARNING: Do not allow familiarity vmh this
type
of product to make you
careless. Remember that a careless fraction of a second is sufficient to
inflict serious injury.
TRIMMING INSTRUCTIONS
1, EXTENSION CORD - Always keep extension cord behind trimmer and
away from the trimming operation, Never drape it over a hedge being
trimmed,
If
you cut or damage the oord, unplug it at the electrical outlet
immediately, before inspecting or repairing cord, You may also place the
extension cord in the holder. FOflll
a
loop in extension cord and push the
throllgh the hole in the rear handle. Position the loop over the cord
and pull back to secure. Connect power cord of unit to extension
cord.
2. WORKING POSITION -Maintain proper footing and balance and do not
overreach. Wear safety goggles, non-skid fool\,vear and rubber gloves when
trimming. Hold the tool firmly in both hands and turn the tool ON. Always
hold the trimmer, as shown with right hand on the switch handle and left
hand on the ball handle. Never hold the tool by the blade guard. Keep unit
below waist level.

Advertisement

loading

This manual is also suitable for:

Ht10024