How To Remove Threads And Hair From The Electrobrush; Cleaning And Care - Miele HS08 Operating Instructions Manual

en
How to remove threads and hair from
the Electrobrush
^ Switch the Electrobrush and the
vacuum cleaner off, switch it off at
the wall socket and remove the plug.
^ Release the vacuum cleaner (dia. 11)
and place it flat on the floor.
^ Turn the vacuum cleaner over.
^ Use scissors to cut any threads or
hairs which have wound around the
roller brush. There is a groove on the
roller to guide you (dia. 33).
Then run the vacuum cleaner to
vacuum up the bits.
The suction hose can be opened up to
clean out any heavy soiling or
blockages. Any large particles inside it
can then be easily removed.
^ Raise the vacuum cleaner into the
vertical position.
^ To access the suction tube handle,
press the release button on the
telescopic tube (dia. 17).
^ To increase stability turn the elbow
joint at the bottom of the hose
downwards as illustrated until it clicks
into position above the retainer (dia.
18).
A Unlock the hose socket by turning it
in the direction of the arrow (see
detail in dia. 34).
B Now remove the hose socket from
the elbow by pulling it (dia. 34).
^ Remove any debris or blockages.
^ Replace the socket making sure it
goes on straight. Lock it into position.
44
If you have not been able to reach all of
the soiling, you could also try the
following.
Unlock the panel on the base of the
vacuum cleaner as follows (dia. 35).
A Using a coin turn the two screws as
far as they will go.
B Lever off the panel.
^ Remove any debris or blockages.
^ Replace the panel and lock it with the
screws.

Cleaning and care

,
Always disconnect the vacuum
cleaner from the electrical supply
before cleaning it. Switch off at the
wall socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic
accessories can be cleaned with a
proprietary cleaner suitable for plastic.
,
Do not use abrasive cleaning
agents, glass cleaning agents,
all-purpose cleaners or oil-based
conditioning agents.
Dust compartment
The dust compartment can, if
necessary, be cleaned using a dry
duster, brush or, if available, a second
vacuum cleaner to vacuum the dust
out.