Advertisement
a.
Mount the Magnetic Mount Antenna outside your vehicle, on a
clean and dry horizontal surface that will always face the sky.
b.
Choose the location for the antenna according to your type of
vehicle. Center it between the left and right sides, and away from
other antennas. Use the Alcohol Prep Pad to clean the surface.
~@
Sedans and Coupes
(above
front windshield
or rear window)
C.
Install the Cable Routing
Adapter to direct the antenna
cable downward, if mounting
on an edge. Then mount the
antenna on the vehicle.
Pickups
(above front
windshield)
Convertibles
(leading edge
of trunk)
'\.
.
1/
SUVs
(rear
of roof)
NOTE: Steps d through f describe the antenna cable routing for a sedan or
coupe
where
the antenna is mounted above the front windshield. The Lynx User Guide has detailed
antenna cable routing instructions for all types of vehicles, online at www.siriusxm.com.
d.
Tuck the antenna cable under the
windshield rubber molding and run it to
the nearest corner.
e.
Route the cable out of the molding and
into the rubber weather stripping around
the door opening. Lift the weather
stripping, tuck and run the cable inside
of it to the bottom of the door opening.
Replace the weather stripping.
TIP: Include enough slack in your cable routing to accommodate open doors or the
hood lid
.
Coil any excess cable in a hidden location and keep it away from any vehicle
pedals or controls.
f.
Run the cable under the dash, or under a floor
mat, bringing it out at the Radio location.
g.
Plug the Magnetic Mount Antenna connector
into the silver ANT connector at the rear the
Vehicle Dock.
h.
Insert the PowerConnect Power Adapter into
your vehicle's cigarette lighter or power adapter
socket. Plug the other end into the red POWER
connector on the rear of the Vehicle Dock.
i.
Place Lynx into the Vehicle Dock and press
the Power button for 3 seconds.
~~
...........
-
~
u~
··········
·
~
JJ
IMPORTANT! Wait until you have connected the audio before
you connect the Vehicle Dock to the Vent Mount.
j.
If you are prompted to take the tour, tap No thanks.
At the next screen tap Continue to be guided through
the activation process.
k.
Be sure the vehicle is parked in a safe place outside,
with a clear view of the sky, and tap Continue.
I.
If Lynx displays Signal Found, tap Continue and
proceed with connecting the audio in the next
section.
If Lynx displays No Signal/Check Antenna,
reposition the vehicle so that nothing is blocking
the antenna's clear view of the sky, and
tap
~
and then Continue to try again.
0
{~:
Advertisement
