Configure the information for each port. This information enables the
spanning tree protocol to calculate the best route to reconfigure the
bridge.
Port Priority
Set the priority of each port. Smaller values are prioritized if the path cost
of each port is the same. You may enter up to 240. The default value is
128.
Path Cost
Set the cost for the frame forwarding of each port. Generally, configure
the cost depending on wired or wireless device standard communication
Bridge Port Settings
rate. In spanning tree protocol, the route whose total cost is lowest is
actually used. 1-200000000 can be entered. The default value is 20000 for
wired ports, 200000 for wireless ports.
Edge Port
Select whether to enable or disable edge port. Edge port is effective
when you connect a device which does not have any bridge to the port.
After the connection, you can communicate immediately. Disabled by
default.
Point to Point
If enabled, ports connect one-to-one to the other bridge. The default is
"Auto-select".
32