Bridge - Buffalo AirStation Pro WAPS-APG600H User Manual

Bridge

Configure bridge parameters here.
Network - Bridge
Rapid STP
Aging Time
BPDU Forwarding
Bridge Priority
Forward Delay
Max Age
Transmit Hold Count
Auto Edge
Select whether to enable or disable rapid spanning tree. The default is
"Off".
Set the time to hold MAC address learned by frame forwarding of the
bridge. If the network configuration is changed frequently, try to set
smaller value to shorten the time of relearning. 1-86400 seconds can be
set. The default value is 300 seconds.
Select whether to enable or disable BPDU forwarding. Enabled by
default.
Configure the priority to recognize the bridge in the spanning tree.
Normally, duplicate ID can be in the same network. The bridge device
which has the smallest priority in the network works as the "root bridge".
Set the time to reconfigure the bridge. Smaller value makes
reconfiguration faster. If the network is massive, the reconfiguration may
not be able to finish by the set time. 4-30 seconds can be set. The default
value is 15 seconds.
Note: This setting is enabled when the AirStation is working as the root
bridge. If it is not the root bridge, this setting is ignored.
Select how long before the AirStation automatically reconfigures the
bridge once it stops receiving BPDU frames. 6-40 seconds can be set. The
default value is 20 seconds.
Note: This setting is enabled when the AirStation is working as the root
bridge. If it is not the root bridge, this setting is ignored.
Specify the maximum number of BPDU sent in 1 second. 1-10 can be
entered. The default value is 6.
Select whether to enable or disable Auto edge. If enabled, the port which
does not receive BPDU for 3 seconds works as the edge port. Disabled by
default.
31