Porter-Cable 725 Porta-Band Instruction Manual page 8

SYMBOL
V ........................ volts
A ........................ amperes
Hz ........................ hertz
W ........................ watts
kW ........................ kilowatts
F ........................ farads
µF ........................ microfarads
l ........................ litres
g ........................ grams
kg ........................ kilograms
bar ........................ bars
Pa ........................ pascals
h ........................ hours
min ........................ minutes
s ........................ seconds
n ........................ no-load speed
0
.../min or ...min
or d.c. ............... direct current
or a.c. ................ alternating current
2
........................ two-phase alternating current
2
N ........................ two-phase alternating current with neutral
3
........................ three-phase alternating current
3
N ........................ three-phase alternating current with neutral
........................ rated current of the appropriate fuse-link in amperes
........................ time-lag miniature fuse-link where X is the symbol
60127
........................ protective earth
........................ class II tool
IPXX
........................
MOTOR
Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60 cycle
A.C. current and voltage within plus or minus 5 percent of that shown on the
specification plate on the tool. Several models, however, are designed for A.C.
current only. Refer to the specification plate on your tool for proper voltage and
current rating.
Do not operate your tool on a current on which the voltage is not
within correct limits. Do not operate tools rated A.C. only on D.C.
current. To do so may seriously damage the tool.
DEFINITION
1
......... Revolutions or reciprocations per minute
-
for the time/current characteristic, as given in IEC
IP
symbol
8